A new 123\SmartBMS gen3 firmware release version is available: v3.3.8.
Changes in v3.3.8:
-“Clear energy counters” now also resets the battery capacity measurements to “Pending measurement”.
For the complete list of new features in firmware v3.3, see this post.
All changes for v3.3
The firmware contains the following changes from v3.3.0:
Changes in v3.3.8
-“Clear energy counters” now also resets the battery capacity measurements to “Pending measurement”.
Changes in v3.3.7
-Sync all key-value pair data in UART protocol to ensure transmitted multi-byte data cannot change during transmission.
Changes in v3.3.6
-Added new key-value pairs to UART protocol which contain extra info like SoH, charge cycles, firmware version etc.
Changes in v3.3.5
-Decreased temperature threshold hysteresis from 4 to 2 °C.
Changes in v3.3.4
-Fixed voltage based SoC correction bug
Changes in v3.3.3
-Added configurable “Sync SoC to full below charge rate %” setting
Changes in v3.3.2
-Fixed voltage based SoC correction bug
Changes in v3.3.1
-Added daily and total battery charged & discharged battery energy (kWh) counters